cpoint-pagebar-web

Home      FluxCell Business       Compensation      States      Questions      Energy Discounts      Technology      Licenses      Business Center     Contact   

Peak Energy      Energy Consumption         Energy as an Investment       Pollution   

Technology

If you were in the year 1946 and someone said that they could take this room of electronics and place it on a chip no bigger than the tip of your finger, would you believe them?  NO , YES 
If you had the opportunity and the means to get in on the ground floor cheaply would you have invested?  NO, YES

cpoint-microchip-web

The Computer
The ENIAC (Electronic Numerical Integrator And Computer) computer became operational in February 1946, measured 8 feet by 3 feet by 100 feet (2400 cubic feet), covered an area of 1800 square feet, weighed 54,000 pounds and consumed 150,000 watts of power.  The speed was 100 kHz and had a cost of $6 million (in today’s dollars).  Today’s desktop computer that can be purchased off the shelf has a speed of 4 GHz, has a volume of .5 cubic feet, costs $2,000 and weighs less than 25 pounds.
This means that today’s speed is 40,000 faster, today’s size is 4,800 smaller and its weight is reduced by a factor of 2160.
When factored all together, today’s computer is an amazing 192 million times as powerful as the ENIAC and 64,000 times cheaper!

The ENIAC used fist sized vacuum tubes to control electronic signals while today’s computers use transistors.  The common denominator in both of these technologies is to use the electron to create signal.  In essence do you use a sledge hammer or a regular hammer to nail a piece of wood together.  The beginning of each of these technologies focused on the mechanical aspects of materials which produced macro technology which were bigger bulkier items such as vacuum tubes and large capacitors.  As time progressed manufacturing techniques were able to produce smaller components that utilized fewer electrons.  The end result is to only utilize the electrons that are necessary to produce the desired end result.

The FluxCell is an exclusive solar technology which moves more electrons so it creates more electricity.  The Flux Capacitor Solar Cell focuses only on the electron to produce more energy.  This is only possible because it utilizes a computer to control every aspect of electron flow in addition to the release of more electrons coupled with the synchronization of time.  What makes the Flux Capacitor Solar Cell different than all other solar cells is size, power and brains.  Current solar cells are passive cells which is why each cell can only produce 4 watts of power.  FluxCell uses active power and one module is designed to power a house.

By obtaining a FluxCell license you gain rights to not only profit from this technology but also the right to save money.  By obtaining an end energy user contract you will secure lower utility bills and contribute to clean air.

One should understand that before the atomic era it was not fully known that the compression or splitting of atoms could produce so much energy.  FluxCell technology taps into the atomic nature of atoms to produce such high power.

FluxCell 2012
Coalesce Point Trust 2007-2012
www.coalescepoint.com